Large Manual Jack Plate (up to 50hp motors) + Install Kit (Complete Setup)

LARGE MANUAL JACK PLATE
- Motor Compatibility: Approved for outboard motors up to 50 HP, including motors with factory power trim and tilt
- Maximum Motor Weight: 230 lbs
- Material: Durable, corrosion-resistant marine-grade aluminum
- Pre-Drilled Mounting: Pre-drilled transom mounting holes help make installation quicker and easier
- Warranty: 3-year housing warranty and 1-year jack warranty

MOTOR CLAMP SPACERS:
- expertly crafted from durable round-cut UHMW (Ultra High Molecular Weight) polyethylene. Unlike traditional wooden spacers, our UHMW spacers offer superior strength and longevity, ensuring reliable support for your outboard motor.

MOUNTING HARDWARE:
- (4) 1/2" x 3 1/2" Mounting Bolts: High-strength .316 stainless steel bolts designed for maximum durability.
- (4) Lock Washers: Prevent loosening over time, ensuring your jack plate remains securely fastened.
- (8) Flat Washers: Provide additional support and distribute load evenly for a sturdy installation.

3M 5200:
- 3M 5200 Marine Adhesive Sealant is a high-strength, permanent marine sealant designed to create a durable, watertight bond above and below the waterline. Known for its exceptional adhesion and flexibility, it seals and protects against water intrusion, vibration, and harsh marine environments.

LARGE MANUAL JACK PLATE
- Weight: 30.6 lbs
- Height: 10 ½ inches
- Width (Transom Side): 16 1/8 inches
- Width (Motor Side): 17 inches
- Setback/Width: 5 ¼ inches from the transom to the motor slide back
- Motor Plate Height: 13 ¾ inches
- Max Rise (Travel): 5 ½ inches, with potential for up to 7 ¾ inches depending on mount location.

MOUNTING HARDWARE
- (4) 1/2″ x 3 1/2″ Mounting Bolts
- (4) Lock Washers
- (8) Flat Washers

MOTOR SPACER CLAMPS
- (2) 1-inch round pucks

Recommended LocTite during installtion